I’m going to try an experiment when I get my table back. As you can see in the pictures from previous posts, the puzzle barely fits the table width wise. The puzzle is about 42″ x 60″, and even though my table is 44″ wide the last inch on either side slopes down slightly into a carved edge. So therefore the edge pieces on the puzzle are also slanting down. I am afraid I’m going to end up losing pieces this way so I’m going to try turning the puzzle 90 degrees so that the width of the puzzle is using the entire length of the table. It will easily fit that way and then I’ll just have to keep the part of the puzzle I’m not working on at the time rolled up at one side of the table. I saw pictures of the people at Jigsaw Jungle (whom I bought the puzzle roll from) did this when they were making the puzzle and it seemed like it worked okay for them. I will just need to make sure my chairs are all the way up against the table so that the puzzle doesn’t roll off the side and “crash.”